I need to remove the driver's seat on a 1967 Porsche 911 (normal) to tighten the bottom front bolt on the seat back L-shaped bracket. (Unfortunately there is not enough room to use a right-angle screwdriver.) I assume that the track must be removed from the car to remove the seat. Is that correct?

If so, attached is a photo of the front end of the left track looking into the car from the outside. There are three 5mm hex bit bolts inside the front end of the track (and two or three more at the rear). Are those the bolts to loosen? Or do I loosen the three bolts outside (lower in the photo) the track that apparently hold the track to the frame? Or use some other method?

Thanks in advance.

Jim

Name: 1967 Porsche 911 seat track front end.JPG Views: 721 Size: 148.6 KB