I've finally got my project car on the road. I took it for inspection yesterday and need to solve a couple little things. Who knew that you needed 2 working seat belts if you only have one seat? I need a seat support rail on the passenger side before I can mount that seat. PM me if you have one!

My ride height is a little low at the front, I was at 25" on the pass side and 23.5 on the driver at the front wheel well. Stock fenders all the way around. I tried measuring from the center line of the wheel and the center line of the torsion bar and taking the difference and even after getting both sides to 25.5", I was getting a difference of over 140mm! Euro ride height as best I can figure it is 108mm. It looks ok now and I'm satisfied, but the 140mm number baffles me!

At the rear, I'm at 23.5" at both wheel wells. I know I need to re-index the spring plates. I found a video on line that speaks to the 40 spline inner and 44 spline outer on the torsion bars and that if you go 1 spline on each in opposite directions you get abut 1.1 degrees of angle change on the spring plate. Here is the question: How much ride height does that translate to? I need to come up about 1.5". I'm doing this on the garage floor and my body will be very thankful if I can do it once and get it right.

Here's the video I watched:https://www.youtube.com/watch?v=GqBw1kMJ_d8

In his second video, he says it's strictly trial and error, but I figured someone on here was smart enough to know how to calc the height based on the angle change.