Help a SWB Brother out: please sell me your extra SWF Wiper blades

[304065]

Just LOOK at this situation . . . .borderline pathetic. And all the originals I have are actually period Bosch.

And I hear it never rains in California so what's the use of a backup set?

Looking for a NOS set for show. Thanks!

[Soterik]

Sorry, I sold my sets. But I'm developing these for the future, can ya wait??

On a side note, two things.

Make sure you get the correct mm for the width of the attachment at the tip of your arms, there's a couple of different versions believe it or not... from memory one is 7mm, and the other is 9mm.

If you find a set to refurbish, I have original SWF rubber for the blades (somewhere.. I do have to find them).

Eric

[Bill Simmeth]

Have you tried Paul?

NOS wipers for sale

[304065]

Are you looking for 280mm or 330mm-


raj

Raj, 330mm (13") please.

[304065]

Sorry, I sold my sets. But I'm developing these for the future, can ya wait??

On a side note, two things.

Make sure you get the correct mm for the width of the attachment at the tip of your arms, there's a couple of different versions believe it or not... from memory one is 7mm, and the other is 9mm.

If you find a set to refurbish, I have original SWF rubber for the blades (somewhere.. I do have to find them).

Eric

Thanks Eric. I have an idea for an ultimate repro for you that I'll share via PM. I'll measure the arms and report back.

[PeterM1965]

Has anyone tried to fit new rubber into the old blades? My hardware is fine but the rubber is getting a bit worn out.

[IAA1963]

I have sold a couple of NOS sets here on the board and do have one original packed set left. I can make a foto and measure it, if you are interested.

Mark

[Soterik]

Has anyone tried to fit new rubber into the old blades? My hardware is fine but the rubber is getting a bit worn out.

I have NOS SWF rubber inserts... I just have to find them. I believe they are in my barn, and I will endeavor to find them.

Eric

[Soterik]

e


do you know if it was always 330mm or was a 280mm used earlier on.Help appreciated

raj

330mm

Maybe you had a "chopped top" at some point? Some secret R project car you had?

e

[beh911]

Has anyone tried to fit new rubber into the old blades? My hardware is fine but the rubber is getting a bit worn out.

If it's the same SWF wiper insert on an SWB car as on a LWB car, then you can get the refill from Stoddard. See this post I made:
http://www.early911sregistry.org/for...l=1#post527734