I am replacing the front suspension pan on my burgundy 1970 911T. I have it trimed and fit in position. The pan came from Restoration Design and fits quite well.
I am replacing the front suspension pan on my burgundy 1970 911T. I have it trimed and fit in position. The pan came from Restoration Design and fits quite well.
Registry #2507
1970 911T
Nice work Rob
Tony
Finished up some trunk stuff.
Brian
S Reg #1032
"I measured twice, cut three times, and it's still too short!"
Obtained some nice original 68 seats and door panels.
Merv
Member # 2633
Cars:
Porsche '68 - 911N (Sold)
Porsche 356B (T-6) S Coupe
Porsche 2008 C2 997 Cabriolet (Sold)
Porsche 2010 Gen.2 Boxster S
Drove it for the first time in twenty years
Larry
Excellent Larry..... adventures start again
Chuck Miller
Creative Advisor/Message Board Moderator - Early 911S Registry #109
R Gruppe #88
TYP901 #62
'73S cpe #1099 - Matched # 2.7/9.5 RS spec rebuild
'67 Malibu 327 spt cpe - Period 350 Rebuild
98 Chevy S-10 Utility
15 GTI Commuter
Finally installed the little white threshold strip rivets. I succeeded only by first cutting off the 'nail', then sanding a soft point in one end, and then 'pre-inserting' it back into the rivet body. From there they were gently tapped into place.
Last edited by Silverbullit; 04-12-2015 at 06:05 PM.
Brian
S Reg #1032
"I measured twice, cut three times, and it's still too short!"
Originally Posted by Larryg57
Drove it for the first time in twenty years
Larry
I'd like to hear more about this.
-Kris Clewell
Professional photojournalist
red decklid club member #1
Ditto. What a bitchin car.
Kenik
- 1969 911S
- 1965/66 911
- S Reg #760
- RGruppe #389
wow nice!! hope she gets out more often, she needs to be seen
Drove it for the first time in twenty years
Larry
Richard aka le Zookeeper
early reg #1128
Posting Permissions
Reply With Quote